Stitch

Directions:

These UVDTF wraps/decals are NOT dishwasher safe.  Do not soak or scrub.  Hand-wash and use warm water with soap only. 

PLEASE READ:  We are NOT responsible for stickers damaged during the application process. No refunds, returns, or exchanges will be accepted.

You will receive 1 UVDTF wrap or decal

  1. When ready to apply, make sure the surface is clean.  Remove any dirt, oil, etc... that may be present.  Allow it to completely air dry before applying.
  2. Gently peel the backing paper/film off the decal.  Be very careful not to touch the adhesive side of the decal as it may leave fingerprints or marks on your transfer.
  3. Carefully position the sticker on the surface. DO NOT try to lift and reposition as it will crack the print.  Use your fingers or squeegee to carefully smooth out any bubbles or wrinkles that may appear. Please take your time to apply and smooth decal from center to edges slowly.
  4. Once applied, use your fingers or squeegee to go over design once more to ensure a great bond with surface. Then, gently start peeling the clear transfer sheet. Once again, go slow to not lift decal abruptly.  If decal does lift, just push back down and apply a little more pressure before trying to remove again.
  5. Let your finished item sit for 24 hours to allow adhesive to cure onto surface.

Size: Wrap approximately 4" x 9" - Decals: 3" x 4"/4" x4"